String pots are intended to gauge direct uprooting. They are ordinarily lower cost than LVDTs and can offer any longer estimation separations. As their name suggests, the reason for string pot is a string or link, and a potentiometer. Fundamentally, a string and a spring are connected to the wiper screw of the potentiometer and as the string is pulled, the potentiometer resistance changes. The string pot gives an adjustment element that depicts what uprooting is spoken to by a rate of resistance change. 

As a basic variable resistance gadget, with a direct yield, most string pots are interfaced to standard A/D sheets. The most widely recognized association arrangement interfaces a voltage reference to the one side of the string pot with the opposite side associated with ground. 

The “wiper” is then associated with an A/D input channel. With the string totally withdrawn, the deliberate voltage will be equivalent to either reference voltage or zero. With the string totally developed, the voltage measured will be the inverse (either zero or the reference voltage). At any middle of the road string expansion, the voltage measured will be corresponding to the rate of string “out”. 

Make sure your voltage reference has the yield current ability to drive the string pot resistance. Your estimation will be a blunder by an indistinguishable rate from any voltage reference mistake. At times, it might be advantageous to drive the string pot with a higher limit, bring down exactness voltage source. Should you require higher exactness than the voltage source gives, you may dependably devote an A/D channel to quantify the voltage source. 

This makes the framework for all intents and purposes safe to blunders in the voltage source. Another note is that string pots are single finished, disengaged gadgets. While associating a string pot to a differential information, make sure to interface the string pot/reference ground and the A/D channel’s low or “- ” input. Neglecting to make this association somehow will probably bring about problematic and even “odd” conduct as the information “- ” terminal buoys all through the info enhancer’s normal mode go.

Share this post

Share on facebook
Share on google
Share on linkedin
Share on twitter

Latest From Blog

Semiconductor Testing

Automated test equipment (ATE) is a computer-controlled test and measurement equipment that allows for testing with minimal human interaction. The tested devices are referred to

Read More »

Subscribe to our newsletter​

Skip to content